Why care for your pump and trigger?

Soap and limescale can build up over time in the pump and trigger which can make them stick, meaning they don’t fully spray or dispense foam as they did. To help with this we advise that some regular pump and trigger care is done every few months when you refill to help things working well.

Step 1: Place the pump/trigger into hot water and submerge for about 30 minutes

Step 2: Remove pump/trigger from hot water and pump through the water using the pump/trigger to remove residue of remaining hand wash or spray cleaner

Step 3: Refill as you normally would and you are good to go

If you are still struggling to release the pump and triggers after you have followed these steps you can buy replacements below or contact us directly for further assistance.